剪切解络-超滤分离金属关键指标预测与验证

根据剪切解络-超滤过程中金属离子的动态浓度关系和质量守恒定律,采用CodeBlocks17.12软件编写程序,建立了剪切解络-超滤工艺关键指标预测模型,实现了金属离子浓度、回收率、体积稀释倍数等指标的预测,并用实验加以验证。依次在转速800 r/min、1 400 r/min、3 000 r/min下回收模拟废水中43 μg/L的Co²⁺、995 μg/L的Ni²⁺和88 μg/L的La³⁺,3种金属的回收率均达99.8%以上时,超滤过程体积稀释倍数的预测值分别为7.0、7.5、5.75,实验值分别为7.5、7.25、6.25,可见预测值与实验值基本一致。本模型对研究方案制定和调整有实际指导意义。     

潮流能水平轴水轮机在剪切来流下的水动力分析

采用基于计算流体力学方法的全尺度数值模拟计算,建立了适用于潮流能水轮机模拟的剪切来流环境,通过数值计算结果,对潮流能水轮机随时间变化的宏观力和流场特征进行了系统分析,探索水轮机在复杂工况下的水动力特性规律。结果表明,水轮机整个叶轮的总体平均受力在剪切流工况中未受到明显影响; 单个叶片的瞬态轴向力系数和瞬态轴向扭矩系数在旋转周期内出现了明显的周期性变化,且周期性变化幅值随转速增大而增大; 非定常的瞬时轴向扭矩和力的周期性振荡容易引起单个叶片的结构性振动,可能对水轮机的机械结构造成影响。     

北洺河铁矿全尾砂胶结充填治理塌陷区的可行性研究

北洺河铁矿为践行“绿水青山就是金山银山”的绿色发展理念,探索利用选厂尾矿治理地表塌陷区方案。通过对北洺河铁矿塌陷区稳定性分析以及对全尾砂膏体制备、输送、胶结充填技术可行性试验研究,并结合经济估算、环境和社会效益等综合分析,认为全尾砂胶结充填治理塌陷区的方案可行。     

入口弯管对矿用轴流通风机气动性能影响的数值研究

以某大型矿用低压轴流式通风机为研究对象, 采用气体动力学性能试验和数值模拟的方法研究了不同入口弯管对风机性能的影响, 重点分析了入口弯管引起的叶轮内部流动特征和损失分布的变化规律。研究结果表明, 风机入口采用弯管连接缩短了进口管道的轴向长度, 节省了地下空间, 但同时来流的均匀性受到影响。弯管内气流速度梯度较大, 管道内侧易发生流动分离, 产生回流区, 增大了流体流动时的能量损失, 风机的整体性能下降。弯管与叶轮入口之间的连接长度会影响内部流场, 当附加直管段较长时, 来流均匀性得到提高, 风机性能有所改善。     

超深溜井爆破一次成井技术实践

为解决溜井掘进效率低、安全性差等问题，以柿竹园多金属矿掘进出矿溜井为例，提出了爆破一次成井技术，根据矿山具体爆破条件，设计了布孔参数、装药结构和起爆顺序等。实践表明，爆破一次成井技术施工天井效果良好，溜井贯穿上下2个分段，与设计相符，相较于普通法施工天井，节约成本30.7%，节约时间58.3%，经济效益显著，施工周期短，且安全性好，值得在其他类似矿山推广应用。     

Use of conditioning time to investigate the mechanisms of interactions of selected fatty acids on hematite Part II laboratory investigations

It is the aim of this paper to examine the effects of conditioning time on the flotation of hematite using three technical grade fatty acid reagents as providing additional evidence on their mechanism of interaction with the hematite surface. Various mechanisms have been postulated as occurring as conditioning time is increased. Both physical (e.g. conditioning time and power input) and chemical (nature, dispersion and solubility of the adsorbing species) contribute to the mechanisms of attachment of collector. In this paper, the mechanism of attachment of oleate to hematite can be readily explained by chemisorption, but the mechanism of attachment of lauric acid appears to be physical adsorption at neutral pH. The flotation of hematite with a mixture of tallow-type fatty acids (palmitic, stearic and oleic acids) is very sensitive to conditioning time, and suggests that, even though flotation is very effective at short conditioning times, it is very susceptible to the presence of fines and their associated high surface areas. It is therefore obvious that both the physical and chemical conditions contribute to the mechanisms of adsorption of fatty acids on iron-containing oxide minerals and must be understood in order to optimise the flotation of these minerals in an industrial situation.     

全尾砂最佳絮凝沉降浓度及调控方式研究

针对新疆某铜矿充填溢流跑浑现象严重、充填尾砂利用率低等问题，对影响尾砂沉降速度的主要因素进行了研究，包括尾砂粒级组成、表面形状和进砂浓度等。通过试验探究了进砂质量浓度分别为10%、15%和20%条件下尾砂沉降高度(H)与时间(T)之间的拟合关系式，其相关系数(R ²)均大于0.975，推导出最有利于该铜矿尾砂沉降的进砂浓度值为16%~17%。通过对比进砂浓度为16.5%条件下沉降试验实测值与预测值，证明该方法能够较好地预测尾砂的最佳沉降进砂浓度值。试验研究及分析为现场生产提供了实际指导，通过增加进砂浓度调节设施，并将各设施的相关参数在充填站控制系统中进行数据联锁，使进砂浓度始终保持在16%~17%之间，絮凝剂的添加量与进砂量匹配并维持在最佳添加量范围内，实现了砂仓顶溢流水澄清，提高了充填尾砂的利用率。     

Physicochemical and environmental characteristics of alkali leaching residue of wolframite and process for valuable metals recovery

Physicochemical and mineralogical characteristics of an alkali leaching residue of wolframite were studied by XRD, SEM?EDS, chemical phase analysis, mineral liberation analyzer (MLA), and TG?DSC methods. Batch leaching tests, toxicity characteristic leaching procedure (TCLP) tests and Chinese standard leaching tests (CSLT) were conducted to determine the environmental mobility of toxic elements. The results show that, due to the high contents of W, Fe, Mn, Sn, and Nb, the residue is with high resource value, but the content of a toxic element, As, is also high. The existing minerals of the investigated elements mainly occur as monomer particles, but it is difficult to extract these valuable metals by conventional acid leaching due to their mineral properties. The release of As increases over time in acidic environment. The leaching concentration of all investigated harmful elements through TCLP is within the limiting value, while the leaching concentration of As through CSLT exceeds the limiting value by more than 4 times, so the residue is classified as hazardous solid waste based on the Chinese standard. A process for valuable metals recovery from this residue was proposed. Preliminary experimental results indicated that the main valuable metals could be extracted effectively.     

基于竹筋-钢筋骨架的人工假顶首层充填厚度研究及现场应用

采用简支梁理论、ANSYS软件数值模拟与现场试验相结合的方法,对竹筋-钢筋骨架人工假顶进行了可行性、受力行为、破坏方式与合理设计参数研究。结果表明,竹筋-钢筋骨架人工假顶结构可有效保护上部充填体,最优充填厚度为4.75 m; 采用竹筋-钢筋配筋方式可兼顾采场稳定性与经济效益,减少支护成本约15%。     

Improving room-temperature electrochemical performance of solid-state lithium battery by using electrospun La2Zr2O7 fibers-filled composite solid electrolyte

Low ionic conductivity at room temperature and poor interfacial compatibility are the main obstacles to restrain the practical application of polymer solid electrolytes. In this work, lanthanum zirconate (LZO) fibers were prepared by electrospinning method and used for the first time as fillers in sandwich polypropylene carbonate (PPC)-based solid electrolyte. Meanwhile, a graphite coating was applied on one surface of the composite solid electrolyte (CSE) membrane. The results show that the LZO fibers significantly increases the room-temperature electrochemical performance of the CSE, and the graphite coating enhances the interfacial compatibility between electrolyte and lithium anode. Furthermore, an ultra-thin PPC-LZO CSE with a total thickness of 22 μm was prepared and used in NCM622/CSE/Li solid-state cell, which shows an initial discharge capacity of 165.6 mAh/g at the current density of 0.5C and a remaining capacity of 113.0 mAh/g after 250 cycles at room temperature. Rise to 1C, the cell shows an initial discharge capacity of 154.2 mAh/g with a remaining capacity of 95.6 mAh/g after 250 cycles. This ultra-thin CSE is expected to be widely applied in high energy-density solid-state battery with excellent room-temperature electrochemical performances.